Tone generator

Play a steady tone at any frequency, to a hundredth of a hertz, or sweep across the range.

Hz

Nearest note A4, 0 cents

Up to 20 kHz on this device
WaveformSine
Volume-15 dB

How to use the tone generator

  1. Set a frequency. Type it into the big number, drag the slider, or tap a mark under it, such as 440 or 1k. Decimals work: 261.63, or 261,63.
  2. Press Play or the Space bar. Start with the volume low and raise it slowly.
  3. Fine-tune. −1 and +1 move a hertz; ÷2 and ×2 move an octave. On a keyboard, ← and → step a hertz (with Shift, a tenth), ↑ and ↓ an octave.
  4. Sweep. Switch the card to Sweep, set where it starts and ends and how long it takes, then press Start sweep. It shows where speakers rattle, where bass fades, and where your hearing tops out.

What a tone generator is good for

Find your tinnitus frequency

Match the pitch of the ringing you hear, at low volume, then check the octave above and below with ×2 and ÷2. Write the number down for your audiologist.

Test speakers and subwoofers

A slow sweep from 20 Hz upwards shows where a subwoofer or speaker starts to play, where a cabinet or a loose panel buzzes, and which frequencies the room boosts. Hold any frequency that rattles and look for the source.

Check your hearing range

Put on headphones, switch to Sweep, start at 8 kHz and choose 1 or 2 minutes. Stop when the tone disappears: that's roughly the top of your hearing. A faster sweep goes past it before you react. It's a rough check, not a hearing test: your equipment's limits affect the result.

Tune an instrument

Play 440 Hz for concert A, or any reference you need. For named notes and an adjustable A4, use the musical note generator.

Check headphones

Play a low tone to hear whether the drivers rattle, and a high one to find where the treble fades. To check that the left and right sides are wired the right way round, use the left–right headphone test.

Frequency ranges at a glance

Which sounds sit in each part of the audible range.

BandRangeWhat you hear there
Sub-bass20–60 HzFelt more than heard: rumble, organ pedals, subwoofers
Bass60–250 HzKick drum body, bass guitar, the warmth of male voices
Low mids250–500 HzFullness, or muddiness when there's too much of it
Mids500 Hz–2 kHzThe core of voices and most instruments; phone speakers live here
Presence2–6 kHzSpeech clarity; hearing is most sensitive around 3–4 kHz
Brilliance6–20 kHzCymbals, air and sparkle; the first range hearing loses with age

Sine, square, triangle or sawtooth?

  • Sine — a pure tone with no harmonics. Use it for tuning, hearing checks and tinnitus matching.
  • Square — strong odd harmonics, hollow and harsh, like an old video game. Good for hearing small speaker defects.
  • Triangle — weak odd harmonics, softer than a square, a little like a flute.
  • Sawtooth — every harmonic at once: buzzy and bright, the raw material of synthesizers.

Listen safely

Start with the volume low and raise it slowly. High tones can sound faint, then suddenly piercing, and a steady tone tires your ears faster than music. Keep sessions short, don't play loud tones into headphones you sleep in, and stop if your ears ring. Very loud low tones can damage small speakers.

Frequently asked questions

Half your audio output's sample rate: 24 kHz at 48 kHz output, which most computers use, and 22.05 kHz at 44.1 kHz. The slider stops there. Speakers and earbuds often stop sooner, around 16–20 kHz.
Most adults stop hearing somewhere between 14 and 17 kHz, and that's normal. Phone and laptop speakers barely play below 100–200 Hz, and Bluetooth often cuts everything above 16–20 kHz. Try wired headphones first.
At low volume, drag the slider until the tone matches the ringing, then fine-tune with −1 and +1. Press ÷2 and ×2 to check the octave, which is easy to get wrong. Take the number to an audiologist: this is a starting point, not a diagnosis.
On iPhones before iOS 17, silent mode mutes web audio: turn it off with the ring/silent switch, the Action button or Control Center. Check the volume and that no call or other app is using the audio. If the tone stops when the screen locks, unlock and press Play again.
Square and sawtooth waves add harmonics at 3×, 5×, 7× the frequency and above, where hearing is most sensitive. The generator plays them a little quieter so switching from sine doesn't jump in loudness.
Yes, at moderate volume and for short periods. Start quiet, especially with headphones and high frequencies, and stop if anything hurts or your ears ring. Very loud low tones can damage small speakers.
Yes. Press Copy link: the link opens the generator with the same frequency and waveform, for example ?f=432&w=square. It doesn't play until the person who opens it presses Play.
No study shows that 432 Hz is healthier or more relaxing than 440 Hz, the concert pitch since 1939. To compare by ear, type 432, then 440, or switch the A4 reference on the notes page.
No, speakers work. Headphones are better for very high and very low frequencies and for checking each ear. In a room, echoes make some frequencies louder than others.